1.5″ RGB OLED Display Module – 16-bit High Colour (128×128)
This is a stunning RGB OLED Display Module measuring 1.5″ diagonally with 128×128 pixels. This high resolution combined with the 16-bit high colour (65K colours) offers incredibly clear and colourful images.
The module has an embedded controller communicating via SPI interface – use it with your favourite SPI-ready development board, such as the Raspberry Pi or Arduino (demo code available)
Features
- 128×128 high resolution, 65K colours – clearly displays colourful images
- Supports 4-wire SPI OR 3-wire SPI interface, configured via onboard resistor
- Comes with online development resources and manual (examples for Raspberry Pi/Arduino)
Package Contents
- 1x 1.5″ RGB OLED Module
- 1x PH2.0 7-pin wire
Resources
- Product Wiki and user guide
Specifications
- Driver: SSD1351
- Interface: 4-wire SPI, 3-wire SPI
- Display colour: RGB, 65K colours
- Resolution: 128×128
- Viewing angle: >160°
- Operating voltage: 3.3V / 5V
- Dimension: 44.5 x 37 (mm)
Interface
| SYMBOL | DESCRIPTION |
|---|---|
| VCC | Power (3.3~5V input) |
| GND | Ground |
| DIN | Data input |
| CLK | Clock data input |
| CS | Chip selection, low active |
| DC | 4-wire SPI: Data/Command selection (high for data, low for command) 3-wire SPI: Connects to GND, keeps low |
| RST | Reset, low active |
There are two available drive interfaces for this RGB OLED module: 4-wire SPI (default) and 3-wire SPI:
| BS | DC | |
|---|---|---|
| 4-wire SPI | 0 | DC |
| 3-wire SPI | 1 | Connects to GND |
